Christmas Tree Stand - Scalable

This stand is built to hold an artificial tree with a friction fit. The stand is made up of 1 hub and 4 legs.

Features:
-Can be scaled to match the trunk diameter of your tree. The hole for the tree trunk is 25.4 mm (1") in diameter. To fit a 1.25" hole, scale to 125%. To fit a 1.50" hole, scale to 150%, and so on.
-Standardized legs can replace broken ABS plastic legs with a slot height of 65 mm (2.6") high and 6.3 mm (0.25") wide.
-Hub has a stop at the bottom to prevent the trunk from falling through. If your trunk is falling through, reduce the scale of the hub so that the hub fits your trunk.

Assembly:
Assembly is simple, just slide the 4 legs into the 4 slots of hub. If necessary, use a rubber mallet to slowly tap the legs into the hub slots. The slots are slightly tapered for a friction fit.

3D Printing Settings:
-There are 2 model files, one for the hub part and one for the leg part. Print one hub part and four leg parts to have a complete stand.
- No supports are needed.
- Models are already in correct orientation for printing and maximum strength. The hub prints in vertical upside-down orientation. The legs print laying on their side.
- Use PETG, ABS or another strong filament. PLA is not recommended. PETG is sufficiently strong.
- For the hub use 100% infill for maximum strength. Legs only need 15% infill.