Dish Scraper Holder Compatible with Kitchen Caddy Organizers

Do you have a organizer at your kitchen sink, but don't have a place for your dish scraper? This simple holder firmly hooks onto your organizer so that you can store your scraper without it getting lost amongst the sponges! The bottom of this holder allows water to drain out.

Fits 2 different size rails on your kitchen organizer:
-small 2 to 3 mm (0.08 - 0.12")
-large 3 to 5 mm (0.12 to 0.20").
Defaults to the small size, but can be enlarged to the large size by prying the areas (in photo) then sliding out the sleeve. https://youtu.be/v7z_TW0y0qA

Dimensions: 78 mm (3.07") L x 32 mm (1.26") H x 17.4 mm (0.69") W. Slot fits scrapers up to 73 mm (2.87") long and 4.9 mm (0.19") wide

3D Printer Settings: Should be printed in the default vertical orientation so that supports are not required. Slicers like Bambu Studio may recommend a brim, but it's not required unless the print is falling over. PETG filament is recommended over PLA for better strength and temperature resistance. I recommend silver or white colors for kitchen aesthetics, but you can use any color. The print has 2 pieces (the holder and a sleeve) that print together in place. See instructions above for optionally removing the sleeve.