Steampunk Stag — Printable STL ( Collectible)

This steampunk stag is a fully printable, stylized decorative sculpture designed for hobbyists and collectors. The model combines realistic anatomy with mechanical plating, rivets and piping for a strong visual impact — ideal as a wall ornament, shelf collectible or centerpiece in dioramas.

Printing recommendations

Recommended printers

Best: Resin (SLA / MSLA / DLP) for highest detail (recommended)

OK: FDM (use a 0.4 mm nozzle with fine layer settings for best results)

Resin settings (SLA / DLP / MSLA)

Layer height: 25–50 µm (0.025–0.05 mm)

Supports: generate supports under antlers, chin, belly, and any overhangs >45°

Orientation: crown/antlers angled slightly upward to reduce support contact on detailed surfaces

Hollowing: model pre-hollowed (3–5 mm wall) with 2–4 drainage holes (Ø 2–3 mm) — remove or modify per preference

Wash & cure: follow resin manufacturer (isopropyl wash 2×, then 2–5 min UV cure depending on resin)

FDM settings

Layer height: 0.12–0.20 mm (0.12 recommended for detail)

Nozzle: 0.4 mm standard; 0.25 mm if available for extra detail

Infill: 10–20% (use gyroid or grid)

Supports: enable supports under antlers, jaw, belly and under thin plates

Adhesion: brim recommended for tall prints; use a sacrificial raft if necessary

Print speed: moderate (30–50 mm/s) for best detail