a pair of hooks designed specifically to be printed in vase mode, for a fast print, low filament use
contains 2 stls
fast printing: a single hook can be printed in around 30-47 minutes using about between 15-17 grs for the toilet holder and 12-14 grs for the smaller hook.
use a double sided tape to stick
this can be used for example as an emergency travel kit.
print in place
3D printing settings
the design has overhangs less than 40 degrees consider lowering the speed of the layer fan to avoid warping during printing and use a small brim in the first layer.
nozzle 0.88 mm, 1 mm
layer height: between 0.20 to 0.35 mm (lower the height for stronger print)
first layer: 0.15 mm (recommended).