Flexi Unicorn and Horse with 3D printed Tail Hair

These Posable and Articulated models are Print In Place and need NO SUPPORT!

The included STL's are an Articulated Unicorn and an Articulated Horse. The horn is the only difference between the two, and the reason is, you may find that the Unicorn's horn may be sharp unless sanded, so I included a hornless Horse for those who want to make these for their younger children.
These models are PRE-SUPPORTED, and the support tower that supports the head can be gently rocked back and forth and snapped off like normal support material after printing.
The Tail can be cut from its supports, at the end closest to the support tower in the back.
The Tail can then be shaped by slowly applying heat from the top down towards the Tail strands with a hair dryer, heat gun, or any other practical heat source.

I hope you Enjoy these Models!
Thank You To Every Single One of You Who Supported The Creative Endeavors Of Myself And All The Artists Here!
HAPPY PRINTING!

3D PRINTER SETTINGS:
NO SUPPORTS NEEDED!
Supports may inhibit the articulation of these models.
I used a brim, as can be seen in the photos, but that was only because it is cold in my printing room this time of year. You may use a brim if you don't mind the extra post processing work, but a brim is not needed, and supports should not be used.
PLA works Great!
The included supports snap off easily with gentle pressure.
The tail is shaped with the application of low heat (Use the appropriate Caution, a little heat goes a long way)