Horned Goat / Ibex Pendant — Heart Holding Figurine - STL file
ID: 28001
$3.54
3D Model Details
-
Texture: Yes
-
Multipart model: No
-
File format: stl
-
File size: 20.93 MB
-
Upload date: 01/20/2026
-
Last update: 03/15/2026
Description
3D model description
This charming horned goat / ibex pendant features stylized fur/linework, expressive eyes, curved horns and an integrated hanging loop — perfect as a pendant, keychain charm, ornament or small display statue. The sculpt holds a heart between its hooves and sits on an ornate round base. The mesh is clean, watertight and supplied as a single-piece STL optimized for both FDM and resin printing.
3D printing settings
FDM (Cura / PrusaSlicer) — recommended slicer settings
Nozzle: 0.4 mm
Layer height: 0.12–0.20 mm (0.12 mm for best surface detail)
Perimeters / Walls: 2–3
Top/Bottom layers: 6–8
Infill: 10–20% (Gyroid or cubic)
Supports: Minimal — loop interior, slight undercuts under chin/hooves may need small supports depending on scale.
Orientation: Upright on the decorative base.
Adhesion: Brim recommended for small prints.
Filament: PLA recommended; PETG for increased toughness.
Estimated filament & time: ~60–160 g PLA and ~6–14 hours at 120 mm (highly dependent on printer & settings).
Resin (MSLA / SLA) — recommended settings
Layer height: 0.05–0.08 mm
Orientation: Tilt 10–25° to reduce flat peel areas and protect facial detail.
Supports: Small touchpoint supports on the back, underside and loop; avoid supports on the face and heart.
Estimated resin usage & time: ~30–110 mL resin; ~3–8 hours depending on size & machine.
This charming horned goat / ibex pendant features stylized fur/linework, expressive eyes, curved horns and an integrated hanging loop — perfect as a pendant, keychain charm, ornament or small display statue. The sculpt holds a heart between its hooves and sits on an ornate round base. The mesh is clean, watertight and supplied as a single-piece STL optimized for both FDM and resin printing.
3D printing settings
FDM (Cura / PrusaSlicer) — recommended slicer settings
Nozzle: 0.4 mm
Layer height: 0.12–0.20 mm (0.12 mm for best surface detail)
Perimeters / Walls: 2–3
Top/Bottom layers: 6–8
Infill: 10–20% (Gyroid or cubic)
Supports: Minimal — loop interior, slight undercuts under chin/hooves may need small supports depending on scale.
Orientation: Upright on the decorative base.
Adhesion: Brim recommended for small prints.
Filament: PLA recommended; PETG for increased toughness.
Estimated filament & time: ~60–160 g PLA and ~6–14 hours at 120 mm (highly dependent on printer & settings).
Resin (MSLA / SLA) — recommended settings
Layer height: 0.05–0.08 mm
Orientation: Tilt 10–25° to reduce flat peel areas and protect facial detail.
Supports: Small touchpoint supports on the back, underside and loop; avoid supports on the face and heart.
Estimated resin usage & time: ~30–110 mL resin; ~3–8 hours depending on size & machine.
Tags
Report this design
