Cute Cat Pendant — Heart Holding Figurine

3D model description
This charming cat pendant features a lovingly sculpted, highly detailed fur surface, expressive eyes, and an integrated hanging loop — perfect as a pendant, keychain charm, ornament, or small display statue. The model sits on an ornate round base and is supplied as a clean, watertight single-piece STL optimized for both FDM and resin workflows.

3D printing settings
FDM (Cura / PrusaSlicer) — suggested settings

Nozzle: 0.4 mm

Layer height: 0.12–0.20 mm (0.12 mm recommended for best fur/detail fidelity)

Walls / perimeters: 2–3

Top / bottom layers: 6–8

Infill: 10–20% (gyroid or cubic)

Supports: Minimal — add supports under the loop interior and any small undercuts flagged by your slicer (underside of hands/heart may need small supports at small scales).

Orientation: Upright with decorative base on the build plate.

Adhesion: Brim recommended for small/tall prints.

Filament: PLA recommended; PETG for added toughness.

Estimates: ~4–12 hours print time and ~40–150 g filament at 100–120 mm (depends on printer & settings).

Resin (MSLA / SLA) — suggested settings

Layer height: 0.05–0.08 mm

Orientation: Tilt model ~10–25° to reduce flat peel areas and spread support stress; orient to avoid supports on the face/heart if possible.

Supports: Use small touchpoint supports on the back and underside; avoid supports on the heart and other front-facing focal details.

Estimates: ~3–8 hours and ~25–90 mL resin depending on size & printer.