Cute Puppy Pendant — Heart Holding Figurine
ID: 27963
$3.54
3D Model Details
-
Texture: Yes
-
Multipart model: No
-
File format: stl
-
File size: 20.72 MB
-
Upload date: 01/16/2026
-
Last update: 03/15/2026
Description
3D model description
This adorable puppy figurine clutching a heart features soft, carved-style fur detail, big expressive eyes, and an integrated hanging loop — perfect as a pendant, keychain, ornament or small display statue. The model is a single, watertight STL with a decorative round base and is optimized for both FDM and resin workflows.
3D printing settings
FDM (Fused Deposition Modeling) — suggested slicer settings
Nozzle: 0.4 mm
Layer height: 0.12–0.20 mm (0.12 mm recommended for best surface/fur detail)
Perimeters / Walls: 2–3
Top/Bottom layers: 6–8
Infill: 10–20% (gyroid or cubic)
Supports: Minimal — add supports under the loop interior and under the underside of the hands/heart if your slicer flags them.
Orientation: Upright on the decorative base.
Bed adhesion: Brim recommended for smaller prints.
Filament: PLA recommended for ease; PETG for durability.
Estimate: ~4–12 hours and ~40–150 g filament depending on size & settings.
Resin (MSLA / SLA) — suggested settings
Layer height: 0.05–0.08 mm
Orientation: Tilt ~10–25° (tilting reduces large flat faces & peel forces)
Supports: Place supports on the back and underside; avoid supports on the face and heart. Use small touchpoints.
Estimate: ~3–8 hours and ~25–90 mL resin (depends on size & printer).
This adorable puppy figurine clutching a heart features soft, carved-style fur detail, big expressive eyes, and an integrated hanging loop — perfect as a pendant, keychain, ornament or small display statue. The model is a single, watertight STL with a decorative round base and is optimized for both FDM and resin workflows.
3D printing settings
FDM (Fused Deposition Modeling) — suggested slicer settings
Nozzle: 0.4 mm
Layer height: 0.12–0.20 mm (0.12 mm recommended for best surface/fur detail)
Perimeters / Walls: 2–3
Top/Bottom layers: 6–8
Infill: 10–20% (gyroid or cubic)
Supports: Minimal — add supports under the loop interior and under the underside of the hands/heart if your slicer flags them.
Orientation: Upright on the decorative base.
Bed adhesion: Brim recommended for smaller prints.
Filament: PLA recommended for ease; PETG for durability.
Estimate: ~4–12 hours and ~40–150 g filament depending on size & settings.
Resin (MSLA / SLA) — suggested settings
Layer height: 0.05–0.08 mm
Orientation: Tilt ~10–25° (tilting reduces large flat faces & peel forces)
Supports: Place supports on the back and underside; avoid supports on the face and heart. Use small touchpoints.
Estimate: ~3–8 hours and ~25–90 mL resin (depends on size & printer).
Report this design
